
Atmel ATWILC1500-MR [PRELIMINARY DATASHEET]
Atmel-42376A-ATWINC1500-MR210P-SmartConnect-Datasheet_102014
8
4 RESET_N I
Active-Low Hard Reset. When asserted to a low level, the module will be
placed in a reset state. When asserted to a high level, the module will run
normally. Connect to a host output that defaults low at power up. If the host
output is tri-stated, add a 1M pull-down resistor to ensure a low level at
power up.
NO
5 NC - No connect
6 NC - No connect
7 NC - No connect
8 NC - No connect
9 GND_1 - GND
10 SPI_CFG I Tie to VDDIO through a 1M resistor to enable the SPI interface NO
11 WAKE I
Host Wake control. Can be used to wake up the module from Doze mode.
Connect to a host GPIO.
NO
12 GND_2 - GND
13 IRQN O
ATWINC1500-MR210PA Device Interrupt output. Connect to host interrupt
input pin.
NO
14 UART_TXD O UART Transmit Output from ATWINC1500-MR210P YES
15 SPI_RXD I SPI MOSI (Master Out Slave In) pin YES
16 SPI_SSN I SPI Slave Select. Active low YES
17 SPI_TXD O SPI MISO (Master In Slave Out) pin YES
18 SPI_CLK I SPI Clock YES
19 UART_RXD I UART Receive input to ATWINC1500-MR210P YES
20 VBATT - Battery power supply
21 GPIO_1 I General Purpose I/O YES
22 CHIP_EN I
Module enable. High level enables module, low level places module in
Power Down mode. Connect to a host Output that defaults low at power up.
If the host output is tri-stated, add a 1M ohm pull-down resistor to ensure a
low level at power up.
NO
23 VDDIO - I/O Power Supply. Must match host I/O voltage
24 1P3V_TP - 1.3V VDD Core Test Point. Leave unconnected
25 NC - No connect
26 GPIO_15 I/O General purpose I/O YES
27 GPIO_16 I/O General purpose I/O YES
28 GND_3 - GND
Table 4-1. Pin Descriptions (Continued)
Pin # Pin Name Type Description
Programmable
Pull-up Resistor
Comentários a estes Manuais